Unitor Carbon remover 25 liters can

Tikweld Welding Supplies and Services is a distributor and supplier of Unitor maintenance and cleaning chemicals in Nigeria. Our Unitor Carbon remover 25 liters can is a powerful non-corrosive solvent for quick break down carbon deposits and very economical in use.

Features of Unitor Carbon Remover

Quickly dissolves deposits containing carbon, resins or varnishes

Eliminates need for hard scraping

Non flammable

Removes carbon type deposits from burner tips, fuel

injectors and all components fouled by carbon, resin or varnishes

Cleans oil side of fuel heaters, oil coolers, etc.

Removes carbon based deposits from fuel and lube oil filters

Can be used for cleaning of: - Pistons - Piston rings - Valve cages

Specification and Physical properties

Appearance       Clear brown

Density [g/ml]   1,0

Flash Point [°C] Above 61

Form   Liquid

pH     10-11 in 5% solution

Directions for use of this product

Soak Method

This method is an effective way of cleaning deposits from components and machine parts. In order to reduce the evaporation of Unitor™ Carbon Remover™ both on the pure product as well as on its emulsions, a skin is formed when exposed to air. The items for cleaning are submerged into the active solvent. A wire basket can be used for small components. Immersion time will depend upon the nature of the deposits to be removed. Light deposits will be removed in 1 hour, whereas heavily oxidized deposits might need longer time. The components should be rinsed thoroughly before handling. Cleaning the Oil Side of Heat

Exchangers

The Unitor™ Chemical Cleaning Unit - Product no. 664 737189 - is recommended to be used.

Isolate the oil supply, disconnect the heat exchanger oil inlet and outlet, and drain off any remaining oil.

Connect the discharge side of Unitor™ Chemical Cleaning Unit (CCU) to the lower heat exchanger connection and fit the return to the CCU.

Add Unitor™ Carbon Remover™ to the drum, product can be diluted with diesel oil down to 25 % and heat, maintaining the temperature (max 50°C) throughout the cleaning operation. If heating is not available, the cleaning time will need to be extended and a higher product concentration is beneficial.

Circulate for 12 hours. When the cleaning is complete, disconnect the lower heat exchanger connection and drain.

Connect a high pressure fresh water supply to the upper heat exchanger connection. Rinse until water runs clear.

Disconnect, drain and dry.

Contact us  for more details