NovaTuff C-300 Epoxy Caulking Compound

NovaTuff C-300 Epoxy Caulking Compound

Tikweld welding supplies and services is the distributor of NovaTuff Epoxy Primer in Nigeria. NovaTuff C-300 is a polyamide, two-component epoxy caulk base sealant. This compound chemically cures into an elastic and flexible body which will not dry out or harden after curing. It does not oxidize or absorb moisture.

Application Areas:

NovaTuff C-300 is an interior or exterior water tight joint sealant for curtain walls, prefab panels, roofs, flashing, coping, and air ducts. It can also be used between similar and dissimilar materials, vertical, and/or horizontal joint work. In extreme cases NovaTuff C-300 can also be applied on to wet surfaces and if necessary can cure underwater.

Features:

NovaTuff C-300 has excellent adhesion to all types of metal, concrete, asphalt, and wood. NovaTuff C-300 is non-staining on masonry surfaces, and no primer is required. This product is also very resilient at low temperatures, and has been tested in boiling water for up to 4 hours. NovaTuff C-300 can also be painted over.

Resistance:

NovaTuff C-300 is unaffected by jet fuel, gasoline, oil, water, caustics, most acids, oil derivatives, and hydrocarbons. For unusual exposures, consult your NovaTuff representative.

Mixing:

The mixing of Part A and B is very important! NovaTuff C-300 has a mixing ratio of 4 parts “B” to 1 part “A” (4:1). Use a power drill and mixing paddle to thoroughly combine both parts. Mix for at least one minute per gallon. Allow idle activation time for a minimum of 10 minutes. Note: Partial mixtures will not work. All parts (Part A & B) must be used and mixed as supplied.

Applications:

NovaTuff C-300 can be applied using; a paint brush, bulk load gun, or a putty knife. Material can be finished with wet hands (use solvent resistant gloves) or tools. Apply only when air temperature is 37° F and rising with no forecasted freeze or snow for a minimum of 48 hours.   Clean Up:

Application equipment should be cleaned immediately with Lacquer Thinner. Use White Cider Vinegar to clean hands and skin. Do not allow NovaTuff to remain on tools! Once it sets and is cured, it is difficult to remove.

Curing Time:

Pot Life – 1   hr   @ 80 ºF

Curing Time-   12 hrs   @ 80 ºF

Complete – 7   days @ 80 ºF

Related article 

Sodium Hypochlorite in Water Treatment: A Powerful Solution for Safe and Clean Water

Introduction to Epoxy Flooring: Benefits and Uses

Epochem Sodium Hypochlorite Disinfectant Best use